Point Cloud for Rhino is a plug-in for Rhinoceros 3.0 and 4.0. Point
Cloud for Rhino adds several new commands to Rhino. It also adds a
new menu to the Rhino menu called "PointCloud" which contains these
newly added commands.
Automatic Loading:
==================
Point Cloud for Rhino has to be loaded into the Rhino before it can
be used. The installer does this automatically. The next time you
run Rhino you will see the "PointCloud" menu added to the Rhino
menu. Due to an installation problem, if the "PointCloud" menu does
not appear then you will have to manually load the plug-in into
Rhino.
Manual Loading:
===============
The Point Cloud for Rhino plug-in files are installed into the Point
Cloud for Rhino installation folder (typically "C:\Program Files\SYCODE\Point
Cloud for Rhino\"). The plug-in files have an extension of ".rhp".
There is one plug-in file for each version of Rhino. The plug-in
file name indicates the version of Rhino that it has been designed
for.
The list of plug-in files along with the version of Rhino is shown
below. Please be sure to use the plug-in file that corresponds to
your version of Rhino.
PointCloud30.rhp -> Rhino 3.0
PointCloud40.rhp -> Rhino 4.0
To load Point Cloud for Rhino into Rhino please follow the steps
listed below:
(1) Start Rhino
(2) Type "PlugInManager" at the command prompt and press "Enter"
(3) Click the "Install" button.
(4) Browse for the plug-in file for your version of Rhino in the
Point Cloud for Rhino installation folder.
(5) Click the "Open" button.
(6) Click the "Close" button.
Usage:
======
Point Cloud for Rhino adds a new menu to Rhino called "PointCloud".
All the new commands can be invoked from this menu.
Support:
========
For support, please
E-Mail support@sycode.com
